Hypertherm Phoenix 8.0 - Manual (Page 357)

Password Setups
350
Input Selection
Defines which inputs are used by the CNC and their physical location on the CNC
interface. All controls are shipped with the default selection of inputs and interface
locations for the selected control interface (I/O) configuration.
Torch Collision Uses
Determines the type of response that is used when the Torch Collision input is active.
You can select to use a Fast Stop Decel value or the Fault Ramp time that has been
selected for the individual axis.
Inputs Inverted
Defines which inputs are used by the CNC and their physical location on the CNC
interface. All controls are shipped with the default selection of inputs and interface
locations for the selected control interface (I/O) configuration.
Drive Enables
Determines how the CNC responds to drive faults. If you select Series, all axes must
complete their individual fault ramp times before the drives are disabled. If you select
Independent, each drive is disabled as soon as its axis fault ramp time is finished.
Initial Feedback Delay
Allows the initial feedback from the drive system to be held off after initial power up.
This allows the drive system to become fully enabled before it enables the position loop.
Fume Extraction Delay
Enter the number of seconds after the end of a cut part program that the fume exhaust
remains on.
Speed Pot and Joystick Overview
Through the use of single-ended inputs to an optional analog input card installed in the
control, your CNC can be configured to support an external joystick or two speed
potentiometers.
Note: These features are not available for all CNC types and optional CNC hardware
may be required.
• The external joystick is used as a directional command signal when it is in manual
motion.
• The optional speed potentiometer can be used to adjust the current motion speed.
• These features must first be enabled at the password-protected I/O screen.
Joystick Installed
Select Yes to enable the optional external joystick. This parameter is not available for all
CNC types and optional CNC hardware is required.