Hypertherm Phoenix 8.0 - Manual (Page 352)

Password Setups
345
Dialog Done
Enter the ASCII code equivalent to the character or symbol used by the host computer for
dialog done.
Dialog Prompt
Enter the ASCII code equivalent to the character or symbol used by the host computer for
dialog prompt.
Dialog Pause
Enter the ASCII code equivalent to the character or symbol used by the host computer for
dialog pause.
Dialog Acknowledge
Enter the ASCII code equivalent to the character or symbol used by the host computer for
dialog acknowledgement.
End of Transmission
Enter the ASCII code equivalent to the character or symbol used by the host computer for
dialog acknowledge.
Using Phoenix Link
Select Yes if you are using the Phoenix Communication link program that is supplied on
the control. The CNC automatically enters the appropriate ASCII codes to the
communication link dialog parameters listed previously.
Show Host File Names
Select whether File Names are shown on the Download from Host screen. This is a time-
saving feature for operators who have very large part folders at the host computer and
know the exact file name of the part program they want to load. The Using Phoenix Link
parameter must be set to ON to enable this feature.
File Dump Mode
Select On to configure the link communication protocol to communicate with link
programs that operate in File Dump Mode. This allows the CNC to accept part programs
as a single uninterrupted stream of information as with a tape reader style link.
Allow M65 Auto Reload
Available when a generic link communication has been enabled and allows you to select
whether the EIA M65 code is used as an auto-reload code or is ignored.
Auto Home before Auto Reload
Automatically homes the machine before the next auto reload (EIA M65 code), either
serial link, USB memory or from diskette, is executed