Hypertherm Phoenix 8.0 - Manual (Page 299)

Pause
292
operator can then use the manual arrow keys to jog the cutting device off path to a
suitable pierce point.
Press Start at this point to cut a new lead-in from the off-path pierce point to the point
along the path from which the cutting device was jogged away. When the cutting device
is back on path, it continues along the path to cut the remainder of the part.
Rush Job Interrupt
Allows the user to pause the current part program and retain the part and current position
information. On the Pause screen, press the Cancel key. A prompt displays on screen to
allow the user the option to save the part information for later use.
If you select Yes, the Resume Last Part button displays on the Files Screen. You can
load and execute another part program and then return to the original part using the
Resume Last Part soft key. The part program and position resumes.