Hypertherm Phoenix 8.0 - Manual (Page 246)

Library Shapes
239
Base Width
Enter the width of the base of the part.
Overall Height
Enter the height of the part from the base to the top.
Bolt Hole Diameter
Enter the length of the diameter of the bolt holes.
Bolt Hole Offset Width
Enter the distance between the center of the bolt holes and the side of the part.
Bolt Hole Offset Height
Enter the distance between the center of the bolt holes and the top or bottom of the part.
Lead In
Overburn Length
Parts that contain a circular element user overburn. Overburn specifies the arc length that
the torch will travel past the circle closure point. The dimension entered is the chord
length of the overburn-arc.
In some cases it is desirable to have an underburn length. For these conditions, enter a
negative number for the overburn length.
Lead Out
Bolt Hole Lead Type
Depending on the shape you select, the style of the lead in/ lead out can be selected as
radius, lock or straight line. The lock style lead-in creates greater stability for the part
and is only available if the part type is set to piece. Lead-in selection is only available if
the part type is set to piece or hole.
Note: Some shapes offer drop down fields to increase options with additional parameters.