Hypertherm Phoenix 8.0 - Manual (Page 394)

Password Setups
387
Tools Installed
Selects or limits the cut modes available to the CNC operator.
Message Enables
The following pull down box is used to enable and disable system messages. To change
the status of a message, highlight the selected message and press the Space key.
Ready to Start Cutting Message
When enabled, the Ready Message feature will display a ready message when the Start
button is pressed.
Kerf Too Large Warning Message
Disables the Kerf Too Large warning message. This message notifies the user that a
conflict between the cut paths and the current Kerf value for a part has been detected and
that some detail could be lost when the part is cut.
Homing Must Be Performed Message
Prompts the operator to home the selected axis before motion begins. The selected axis
must have homing enabled on the axes setup screen.
Values Have been Changed Message
Displays as a confirmation when changes to values on the current configuration screen
are detected. This ensures that changes are not made in error when exiting the screen.
Home Torch Height Control Message
Prompts the operator to home the Sensor THC axis at power up and before motion
begins.
Ready to Final Align Message
Appears as part of the skew alignment function and displays just before final motion to
position the tool begins.
Part Larger than Plate Message
Displays when the dimensions of the part that have been loaded exceed the selected plate
dimensions.
Cut Chart Data Has Changed Message
Displays as a confirmation when changes to the values on the current Cut Chart screen
are detected. This ensures that changes are not made in error when exiting the screen.