Hypertherm Phoenix 8.0 - Manual (Page 252)

Library Shapes
245
Base Width
Enter the width of the base of the part.
Overall Height
Enter the height of the part from the base to the top.
Corner Radius
Enter the radius of the convex corners.
Center Diameter
Enter the diameter of the central hole.
Bolt Hole Diameter
Enter the diameter of the bolt holes.
Bolt Hole Offset Width
Enter the distance between the center of the bolt holes and the side of the part.
Bolt Hole Offset Height
Enter the distance between the center of the bolt holes and the top or bottom of the part.
Lead In Radius
Enter the radius of the lead-in arc.
Overburn Length
Parts that contain a circular element user overburn. Overburn specifies the arc length that
the torch will travel past the circle closure point. The dimension entered is the chord
length of the overburn-arc.
In some cases it is desirable to have an underburn length. For these conditions, enter a
negative number for the overburn length.
Lead Out Radius
Enter the radius of the lead-out arc.