INFICON Cygnus Thin Film Deposition Controller - Manual (Page 101)

4 - 17
IP
N 07
4-
37
9-
P1
K
Cygnus Operating Manual
4.6 I/O Map
The I/O Map is selected by pressing the F2 key (I/O MAP) in the General
Parameters display. On the I/O MAP display, the desired I/O Board is chosen with
the box cursor. The I/O Map display is shown in
Figure 4-12 . Upon entry the cursor
will be placed at the last referenced output or input number.
Figure 4-11 Display Tree for I/O Map Editing
Figure 4-12 I/O Map Board Display
I/O MAP Display Function Keys
F1 EDIT NAME
Pressing this key will display a series of 10 underscores representing ten
positions. The left and right arrow keys are used to move back and forth among
the 10 positions. The up and down arrow keys are used to scroll through an
alphanumeric listing, A through Z, 0 through 9, and the following characters: !,
#, _, ~, %, & and -. Once the desired character is displayed, pressing the E key
enters the character and advances the reverse video cursor box to the next
position.
ALL CHANNELS
GENERAL PARAMETERS
I/O MAP