INFICON Cygnus Thin Film Deposition Controller User Manual
Page 38
2 - 2
IP
N 07
4-
37
9-
P1
K
Cygnus Operating Manual
4 System Switches
An array of four keys that provide START, STOP, RESET and STOP ALL
functions, for process control.
5 3.5" Floppy Disk Access Port
Receptacle for the optional 3.5", 1.44 MB floppy disk.
6 Stop ALL Key
A key which when pressed will place all channels in a STOP state regardless
of the screen display.
7 Power
This switch controls secondary power to the instrument between ON and
STANDBY. Power is provided when the button is in its depressed position. The
instrument is initialized for approximately 5 seconds before providing an
operational screen.
8 Pilot Light
A green pilot light, adjacent to the power switch, is illuminated when power is
on.
9 Remote Control Jack
Receptacle for the wired hand-held remote controller.
10 Cursor Keys
An array of four keys that are used to move the display cursor either up, down,
left or right. The keys auto-repeat; the cursor will continue to move as long as
the key is held down or until a display field boundary is met.
11 Brightness Adjustment
An access hole for the display’s brightness adjustment potentiometer. Use a
nonconductive TV adjustment tool to increase the brightness by turning the
potentiometer clockwise.