INFICON Cygnus Thin Film Deposition Controller - Manual (Page 102)

4 - 18
IP
N 07
4-
37
9-
P1
K
Cygnus Operating Manual
The following names are used by Cygnus to identify the relays selected for the
corresponding functions:
SBSTR_SH#
XTL_SHTR_#
CRUC1CHN_#
CRUC2CHN_#
CRUC3CHN_#
CRUC4CHN_#
CRUC5CHN_#
CRUC6CHN_#
The following name is used by Cygnus to identify the INPUT selected for the
turret switch feedback function.
TURRET_#
The value for '#' may range from 1 to 6 corresponding to the number of
available channels.
To avoid confusion, it is recommended that you do not use these names.
The value for number may range from 1 to 6 corresponding to the number of
available channels.
F2 SAVE NAME
Pressing this key saves the Name of the Input or Output. Once saved, this
Name will be displayed whenever this Output (or Input) is chosen in the Edit
Logic Display.
F3 CANCEL NAME CHANGE
Pressing this key cancels any changes to the Name made after pressing the F1
KEY (EDIT NAME).
F4 CLEAR NAME
Pressing this key clears the Name associated with the designated output (or
input).
F5 TOGGLE TYPE
Pressing this key toggles the output type from Normally Open (NO) to Normally
Closed (NC).
F6 GENERAL PARMS
Pressing this key returns the display to the General Parameters display.