INFICON Cygnus Thin Film Deposition Controller - Manual (Page 39)

2 - 3
IP
N 07
4-
37
9-
P1
K
Cygnus Operating Manual
2.2 Rear Panel Interfaces
Interfaces for Cygnus are located on the rear panel of the instrument as depicted
in
Figure 2-2 .
Figure 2-2 Cygnus Rear Panel
1 IEEE488 Connector (Optional)
Provides connections for IEEE-GPIB interface.
2 Digital to Analog Converter (optional)
Provides recorder output for six channels (15 pin miniature D-sub connector).
Outputs are programmable for recorder function.
3 Sensor Connectors - Channels 1 & 2 (standard)
Provides connection for the units two standard sensor channels.
4 Sensor Connectors - Channels 3 & 4 (optional)
Expansion panel to accommodate the optional addition of two more sensors,
sensors 3 & 4.
5 Sensor Connectors - Channels 5 & 6 (optional)
Expansion panel to accommodate the optional addition of two more sensors,
sensors 5 & 6.
6 8 Relay x 14 Input I/O Card (standard)
Provides pin connection for 8 Relays rated for 30 V(dc) or
30 V(ac) RMS or 42 V(peak) maximum, and 14 TTL Inputs.
7 8 Relay x 14 Input I/O Card (optional)
Provides pin connection for 8 relays rated for 30 V(dc) or
30 V(ac) RMS or 42 V(peak) maximum, and 14 TTL inputs.
1 2 3 4 5 6 7 8 9 10
11 12 13