INFICON Cygnus Thin Film Deposition Controller - Manual (Page 64)

2 - 28
IP
N 07
4-
37
9-
P1
K
Cygnus Operating Manual
2.7.4 Hand-Held Controller
A Hand-Held Controller, see Figure 2-13 , is provided as an accessory with the
Cygnus. The Controller serves as a wired remote to manually control power, switch
crystals and produce a STOP.
The Controller is attached to the instrument with a modular plug to the front panel.
Power is affected (only when in Manual mode) by moving the POWER/STOP
switch laterally. A STOP is produced by moving the POWER/STOP switch down
(only when in Manual mode). An All STOP is performed when the STOP function
is pressed twice within one second, or is continuously pressed. When in a READY
or STOP state and the instrument is on the SENSOR Maintenance display, a
crystal switch is activated by pressing the red button on the body of the controller.
The ship kit includes a convenience hook for the Controller that can be attached to
the instrument’s mounting ears or some other accessible location.
Figure 2-13 Hand-Held Controller