5 crystal snatcher, 6 crystalsix, 7 crystal12 – INFICON Cygnus Thin Film Deposition Controller User Manual
Page 190
Advertising
8 - 24
IP
N 07
4-
37
9-
P1
K
Cygnus Operating Manual
8.3.5 Crystal Snatcher
Use the crystal snatcher, supplied with the sensor, as follows:
1
Insert crystal snatcher into ceramic retainer (1) and apply a small amount of
pressure. This locks the retainer to the snatcher and allows the retainer to be
pulled straight out (2).
2
Reinsert the retainer into the holder after the crystal has been replaced.
3
Release the crystal snatcher with a slight side-to-side motion.
Figure 8-4 Use of the Crystal Snatcher
8.3.6 CrystalSix
Refer to the CrystalSix Operating Manual (IPN 074-155) for specific instructions for
this device.
8.3.7 Crystal12
Refer to the Crystal12 Operating Manual (IPN 074-398) for specific instructions for
this device.
Advertising