INFICON Cygnus Thin Film Deposition Controller - Manual (Page 166)

7 - 8
IP
N 07
4-
37
9-
P1
K
Cygnus Operating Manual
enter the appropriate Final Thickness values into Channels N and (N+1) and
set the Max Power Option for each channel to the desired value. Enter the
correct values for Density and Z-Ratio parameters for Channel N and (N+1).
Enter the desired value into the Auto-Z parameter for Sensor Channel N and
(N+1).
12 Enter the appropriate Cross Talk Percent values into the definitions for
Channels N and (N+1).
This completes the calculation of Cross Talk Percent values. The instrument is now
ready for co-depositions.