INFICON Cygnus Thin Film Deposition Controller - Manual (Page 104)

4 - 20
IP
N 07
4-
37
9-
P1
K
Cygnus Operating Manual
The key choices are changed to CONTINUE and CANCEL. Selecting
CONTINUE saves the file to the diskette. Selecting CANCEL returns the
display to the Configuration Files display.
F2 LOAD FROM FLOPPY
Pressing this key will select the Configuration File contained within the box
cursor and prompt the user to “Load the file FILENAME.ISC?”. The key choices
are changed to CONTINUE and CANCEL. Selecting CONTINUE loads the
contents of the file into Cygnus. Selecting CANCEL returns the display to the
Configuration Files display.
F3 DELETE
Pressing this key will select the Configuration File contained within the box
cursor and prompt the user to “Delete the file FILENAME.ISC?”.
F5 ALL FILES
Pressing this key provides a directory of all the files contained on the diskette.
From the ALL FILES display, function keys for DELETE, CONFIG FILES, and
GENERAL PARMS are available.
F6 GENERAL PARMS
Pressing this key returns to the General Parameters display.
CAUTION
Do not remove the diskette during SAVE or LOAD
operations.
It is recommended that when doing a LOAD operation,
the instrument have the same hardware configuration,
including optional Sensor Measurement Boards, as when
the parameters were saved to diskette.
If the file retrieved from the floppy diskette contains
parameters which are valid only with optional equipment
installed, these parameter values will not be altered.