2 sensor installation – INFICON Cygnus Thin Film Deposition Controller User Manual
Page 145
Advertising
6 - 3
IP
N 07
4-
37
9-
P1
K
Cygnus Operating Manual
6.1.2 Sensor Installation
shows a typical installation of an INFICON water cooled crystal sensor
in the vacuum process chamber. Use the illustration and the following guidelines to
install your sensors for optimum performance and convenience.
Figure 6-1 Typical Installation
Mounting Bracket
Coax Cable
(Routed with
Water Tubes)
Or,
Customer Supplied
Cajon Coupling
Brazing
Adapters
Water In
Water Out
XIU (Oscillator)
Instrument Chassis
Source
Source
Shutter
Pneumatic
Actuator
To
Source Controller
Source to Sensor
10" Minimum
Sensor
Shutter
Air, 80 PSI, 110 PSI Max.
To
Sensor
Shutter
IPN 750-420-G1
Shutter
Solenoid
Assembly
Advertising