INFICON Cygnus Thin Film Deposition Controller - Manual (Page 31)

1 - 17
IP
N 07
4-
37
9-
P1
K
Cygnus Operating Manual
1.5 Unpacking and Inspection
1 If the Cygnus control unit has not been removed from its shipping container, do
so now.
2 Carefully examine the unit for damage that may have occurred during shipping.
This is especially important if you notice obvious rough handling on the outside
of the container. Immediately report any damage to the carrier and to INFICON.
3 Do not discard the packing materials until you have taken inventory and have
at least performed a power on verification.
4 Take an inventory of your order by referring to your order invoice and the
information contained in
section 1.6 on page 1-17 .
5 To perform a power-on verification, see section 1.7 on page 1-20 .
6 For additional information or technical assistance, contact your nearest
INFICON Inc. sales office.
1.6 Parts and Options Overview
1.6.1 Base Configurations
Cygnus Control Unit . . . . . . . . . . . . . 779-700-G1 (100 V(ac) 50/60 Hz)
779-700-G2 (120 V(ac) 50/60 Hz)
779-700-G3 (230 V(ac) 50/60 Hz)
779 -700 -G4 (240 V(ac) 50/60 Hz)
Technical Manual . . . . . . . . . . . . . . . 074-379
Hand Controller . . . . . . . . . . . . . . . . 755-262-G1
I/O Relay Ship Kit . . . . . . . . . . . . . . . 760-024-G1
Power Cord . . . . . . . . . . . . . . . . . . . 068-0433
(shielded power cord - North America)
068-0434
(shielded power cord - European)
Ship Kit . . . . . . . . . . . . . . . . . . . . . . . 779-610-G1 (100 V(ac), 120 V(ac))
779-610-G2 (230 V(ac), 240 V(ac))