INFICON Cygnus Thin Film Deposition Controller - Manual (Page 99)

4 - 15
IP
N 07
4-
37
9-
P1
K
Cygnus Operating Manual
GOTO POST DEP ###
This action places the designated Channel ### into the Idle Ramp state. This
action cannot be done if in Crucible Switch.
INCREMENT COUNT ###
Increases the count by one in the designated counter ###.
RESET ###
This action is identical to pressing the RESET button on the front panel for the
designated Channel ###. When 0 is entered all the Channels will be RESET.
RW SAMPLE ON ###
Leave RateWatch HOLD on Channel ### and do not return to RateWatch
HOLD until turned off.
RW SAMPLE OFF ###
Allows return to RateWatch HOLD on Channel ### when sampling accuracy
has been met.
START ###
This action is identical to pressing the START button on the front panel for the
designated Channel ###.
START DEPOSIT ###
This function is used to place the designated Channel ### into Deposit from the
NONDEP CNTL state. If the crystal is failed this command will make the source
go into Time Power if the previous state was Non-Deposit Hold, otherwise the
action is not allowed. Can not be done from Ready, Stop, or Crucible Switch.
When in Ready or Stop use the Start action.
START TIMER ###
Starts the designated timer ###.
STOP ###
This action is identical to pressing the Stop button on the front panel for the
designated Channel ###. A value of 0 stops all channels.
SWITCH XTAL ###
This Action activates the Crystal Switch output for the sensor number indicated.
It sets the alternate crystal active when using CrystalTwo Switch. It indexes to
the next crystal position when using the CrystalSix, Crystal12, or Rotary sensor.
This function is available only if a CrystalTwo, a CrystalSix, Crystal12, or a
Rotary sensor type is chosen.