Basler Electric DECS-400 - Manual (Page 229)

9369700990 Rev R 217
Holding Registers for Operating Mode Parameters
Table 38. Information Category C4—Operating Mode Parameters
Registers Data Description Access
Data
Format
40601 Virtual toggle switch for changing unit mode from stop to start. Value 1 is
only valid to apply. Reading this register provides the status: 0=STOP,
1=START. RW UINT16
40602 Virtual toggle switch for changing control from AVR mode to Manual mode.
Value of 1 is the only valid value to apply. Reading this register provides the
control mode status: 0=base mode, 1=manual, 2=AVR. RW UINT16
40603 Virtual toggle switch for changing operation between unit and parallel.
Value 1 is only valid to apply. Read value of register is aloways 0. RW UINT16
40604 PF/Var Enabled 0=off, 1=PF, 2=var RW UINT16
40605 Internal Tracking Enabled RW UINT16
40606 Pre-position 1 Enabled RW UINT16
40607 Raise Enabled RW UINT16
40608 Lower Enabled RW UINT16
40609 LimiterMode; 0=off, 1=UEL, 2=OEL, 3=UEL&OEL, 4=SCL, 5=UEL&SCL,
6=OEL&SCL, 7=UEL&OEL&SCL, 8=VARL, 9=VARL&OEL,
10=VARL&OEL, 11=VARL&OEL&UEL, 12=VARL&SCL,
13=VARL&SCL&OEL, 14=VARL&SCL&OEL, 15=VARL&SCL&UEL&OEL RW UINT16
40610 Voltage Matching Mode (0=off, 1=on) R UINT16
40611 Operating Mode (0=off, 1=PF, 2=var) R UINT16
40612 Unit mode where 0=stop, 1=start R UINT16
40613 Control Mode (1 = Manual, 2 = AVR) R UINT16
40614 Internal Tracking Enabled R UINT16
40615 Pre-position Enabled R UINT16
40616 Auto Transfer Enabled R UINT16
40617 Load Comp Mode (0=off, 1=droop, 2=L droop, 4=CCC) R UINT16
40618 Alarm Reset Enabled RW UINT16
40619 Loss Of Sensing Mode RW UINT16
40620 No Sense To Manual Mode RW UINT16
40621 External Tracking Enabled RW UINT16
40622 Underfrequency Mode RW UINT16
40631 Droop Enabled RW UINT16
40632 L Drop Enabled RW UINT16
40633 CC Enabled RW UINT16
40634 OEL Style Mode R UINT16
40635 External Tracking Enabled R UINT16
40636 OEL Style Enabled RW UINT16
40637 Pre-position 2 Enabled R UINT16
40638 UEL Style Mode R UINT16
40639 OEL Option Mode R UINT16
40640 Pre-position Selection R UINT16
40641 UEL Style Enabled RW UINT16
40642 Voltage Matching Enabled RW UINT16
40643 OEL Enabled RW UINT16
40644 UEL Enabled RW UINT16
40645 SCL Enabled RW UINT16
40646 Internal Tracking Mode R UINT16
40647 External Tracking Mode R UINT16
40648 Voltage Matching Mode R UINT16
40649 to
40674 Reserved for future C4 use R Not
Defined
40675 Var limiter enable; 0=disable, 1=enable RW UINT16
40720 Enables traverse rate to pre-position 1 for the mode RW UINT16
40721 Enables traverse rate to pre-position 2 for the mode RW UINT16
40722 Enables traverse rate to pre-position 1 for the mode RW UINT16
40723 Enables traverse rate to pre-position 2 for the mode RW UINT16
40724 Enables traverse rate to pre-position 1 for the mode RW UINT16
40725 Enables traverse rate to the pre-position 2 for the mode RW UINT16
DECS-400 Modbus™ Communication