IDEC FS1A Controller - Manual (Page 21)

PRODUCT SPECIFICATIONS
2-9
Chapter 2
Safety output specifications
Output type Source output (N channel MOSFET)
Rated output voltage Power supply voltage
Minimum voltage Power supply voltage - 2.0V
Number of output terminals 4 (Y0, Y1, Y2, Y3)
Point 500mA maximum
Maximum output current
total 1A maximum
Leakage current 0.1mA maximum
Allowable inductive Load Note1 L / R = 25ms
Allowable capacitive load 1uF maximum
Cable length Note2 100m maximum (total wiring length per 1 output)
Note1. For protection of output circuits, protection devices such as diodes should be connected
to output circuits with inductive loads.
Note2. For cables longer than 30m between SafetyOne and connected devices, use grounded
shielded cables to assure electromagnetic compatibility.
Safety output equivalent circuit
Internal
circuit
Logic
circuit
Y0～Y3
V-
V+
Safety outputs of the SafetyOne are semiconductor outputs. For diagnostics of the shut-off
function, the SafetyOne generates off-pulses in certain intervals when the outputs are in ON
state. The specifications of the safety outputs changes depending on the Logic selected. See
further information in “Chapter 5 LOGIC”. But basic specifications are same.
OFF
ON
OFF interval: approx. 40ms
OFF time: approx. 400μs
Caution
Check the response time of external devices so that they do not correspond to the off pulses.
Monitor and solenoid/lamp outputs do not generate off pulses.