IDEC FS1A Controller - Manual (Page 7)

BEFORE GETTING STARTED
Thank you for your purchase of the IDEC SafetyOne (Type Number FS1A-C11S).
This user’s manual describes the specifications, and the procedures for installing and operating
the SafetyOne.
Read this manual carefully before using the SafetyOne so that you have an adequate
understanding of its functions and performance.
„ About directives and standards
SafetyOne is approved for following directives and standards by TÜV SÜD.
1. EU directives
-Machinery Directive: Directive 98/37/EC (Valid until 29.Dec.2009)
-Machinery Directive: Directive 2006/42/EC
-EMC Directive: Directive 2004/108/EC
2. EN standards / IEC standards / ISO standards
IEC 61508 Part1-7, EN 954-1, EN ISO 13849-1, IEC/EN 62061, IEC/EN 61496-1,
IEC 60204-1, NFPA 79, IEC/EN 61131-2, IEC 61000-6-2, IEC/EN 61000-6-4
SafetyOne is approved for following directives and standards by UL.
1. UL standards
- UL 508
2. CSA standards
- CSA C22.2 No.142
SafetyOne has not undergone the type examination in accordance with Article 44-2 of the
Japanese Industrial Safety and Law. SafetyOne, therefore, cannot be used in Japan as a
"Safety Device for Press or Shearing machine" as established in Article 42 of that law.
• The reproduction, transfer, sale, assignment, or loan of any or a part of this manual is strictly
prohibited.
• The contents of this manual are subject to change without notice.
• Thorough measures have been taken in preparing the contents of this manual; however, in the
case you find an error or the like, please bring it to the attention of your IDEC sales
representative.
NOTE