IDEC FS1A Controller - Manual (Page 235)

LOGIC
5-187
Chapter 5
Intended inputs
(Terminal names) Function
Function name Dual channel direct opening input
Symbol
Dual Channel
Direct Opening
Description of operation This function diagnoses the status of
connected safety devices. This function
diagnoses the time interval of status
transition between each input of
duplicated inputs (0.5s).
Safety input 6
(X12-T12, X13-T13)
Detail information Logic functions (5-311)
Warning
For connected control devices, refer to “SAFETY PRECAUTIONS”.
Safety check signals (pulses signals) are sent from the drive terminals (T0, T2, T4 to T7, T12, T13) to
diagnose connected safety devices and input circuits. Safety check signals can not be used as a
power supply for connected devices.
Note. Solid state outputs, such as safety light curtains, can not be connected to safety input 1 through
Safety input 4, and safety input 6.
Note. Use safety input 1 through safety input 4, and safety input 6, as specified combinations, such as
receive terminal (Xn) and drive terminal (Tn). If the combinations are incorrect, SafetyOne does
not work correctly.
Note. When SafetyOne is in Run state or Protection state, input states are monitored in all safety
inputs. For example, if input monitor error is detected in safety input 3 or safety input 4 although
AUTO mode is selected, SafetyOne detects error and transits to Protection state.
Note. If there are unused safety inputs in safety input 3, safety input 4 or safety input 6, connect the
unused receive terminals (Xn) to the corresponding drive terminals (Tn). If they are not
connected, the SafetyOne does not turn ON the safety outputs.
Note. If safety input 5 is not used, connect the receive terminals (X10 and X11) to a 24V DC power
supply (V+). If they are not connected, the SafetyOne does not turn ON the safety outputs.