IDEC FS1A Controller - Manual (Page 35)

INSTALLATION AND WIRING
3-5
Chapter 3
■ Installing on DIN Rails
Mount and remove SafetyOne on 35mm-wide DIN rails according to the following instructions.
Applicable DIN rail: (for example) BAA1000 (IDEC)
Mounting on DIN rail
1. Fasten DIN rail to a panel using screws.
2. With the top of SafetyOne unit facing up, as shown in Fig. 3.4, insert the groove, on the rear
of the unit, and press the unit in the direction of the arrow.
3. Use BNL6 (IDEC) mounting clips (sold separately) on both sides to prevent it from moving
sideways.
Clamp
Fig. 3.4 Mounting
Removing from DIN Rail
1. Insert a flat screwdriver into the slot in the clamp.
2. Pull the clamp until you hear a click, as shown in Fig. 3.5.
3. Remove SafetyOne from the bottom.
Fig. 3.5 Removing
35mm-wideDIN rail
35mm-wideDIN rail
Clamp