Allied Telesis AT-S63 - Manual (Page 109)

AT-S63 Management Software Web Browser Interface User’s Guide
Section I: Basic Operations 109
Deleting a Port Trunk
Caution
Disconnect the cables from the port trunk on the switch before
performing the following procedure. Deleting a port trunk without first
disconnecting the cables can create loops in your network topology.
Data loops can result in broadcast storms and poor network
performance.
To delete a port trunk from the switch, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by default,
as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Layer 1 option.
The Layer 1 page opens with the Port Settings tab displayed by
default, as shown in Figure 20 on page 78.
3. Select the Port Trunking tab.
The Port Trunking tab is shown in Figure 29 on page 105.
4. Click the button next to the port trunk you want to delete and click
Remove.
The port trunk is deleted from the switch.
5. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)