Allied Telesis AT-S63 - Manual (Page 279)

AT-S63 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 279
5. Click OK.
6. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Modifying a
Target
Parameters Table
Entry
To modify an entry in the SNMPv3 Target Parameters Table, perform the
following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 38.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 89 on page 234.
3. In the SNMPv3 section, click the button next to Configure Target
Parameters Table and then click Configure at the bottom of the tab.
The SNMPv3 Target Parameters Table tab is shown in Figure 108 on
page 275.
4. Click the button next to the Target Parameters Table entry that you
want to change, and then click Modify.
The Modify SNMPv3 Target Parameter page is shown in Figure 110 on
page 279.
Figure 110. Modify SNMPv3 Target Parameter Page