Configuring tacacs – Allied Telesis AT-S63 User Manual
Page 438
Chapter 28: TACACS+ and RADIUS Protocols
438
Section VII: Management Security
Configuring TACACS+
To configure TACACS+, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38
2. Select the Server-based Authentication tab.
The Server-based Authentication tab is shown in Figure 175 on page
436.
3. In lower section of the Server-based Authentication tab, click
TACACS+ Configuration and click Configure.
The TACACS+ Client Configuration page is shown in Figure 176.
Figure 176. TACACS+ Client Configuration Page
4. Configure the following parameters as necessary.
Global Secret
If all of the TACACS+ servers have the same encryption secret, you
can enter the key here. If the servers have different keys, you must
specify each key when you specify a server’s IP address. The
maximum key length is 39 characters.