Configuring mstp port parameters – Allied Telesis AT-S63 User Manual
Page 332
Chapter 20: Multiple Spanning Tree Protocol
332
Section IV: Spanning Tree Protocols
Configuring MSTP Port Parameters
To configure MSTP port parameters, perform the following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab selected by
default, as shown in Figure 25 on page 94.
3. Select the Spanning Tree tab.
The Spanning Tree tab is shown in Figure 133 on page 320.
4. Click Configure.
The expanded MSTP Spanning Tree tab is shown in Figure 134 on
page 323.
5. In the diagram of the switch at the bottom of the MSTP Spanning Tree
Expanded page, click the ports you want to configure. You can select
more than one port at a time.
6. Click Modify.
The MSTP Settings - Port(s) page is shown in Figure 137.
Figure 137. MSTP Settings - Port(s) Page