Allied Telesis AT-S63 - Manual (Page 378)

Chapter 23: Protected Ports VLANs
378 Section V: Virtual LANs
Creating a New Protected Ports VLAN
To create a new protected ports VLAN, perform the procedure below:
1. From the Home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab selected by
default.
3. Select the VLAN tab.
The VLAN tab is shown in Figure 141 on page 346.
Note
The Modify and Remove buttons are not included in the tab if the
only VLAN on the switch is the Default_VLAN.
This tab displays the VLANs in a table that contains the following
columns of information:
VLAN ID
The VID number assigned to the VLAN.
(Client) Name
The name of the VLAN.
Uplink Port
This column is applicable only when the switch is operating in one of
the two multiple VLAN modes. The column lists the port that is
functioning as the uplink port for the other ports on the switch.
Type
This column contains “Port Based” for both port-based and tagged
VLANs, “GVRP Dynamic” for VLANs created by GVRP, and
“Protected” for protected ports VLANs.
Protocol
Not used.
Tagged(T)/Untagged(U) Port
Lists the ports of the VLAN. Tagged ports are designated with a “T”
and untagged ports with a “U.”
4. To create a new protected ports VLAN, click Add.