Allied Telesis AT-S63 - Manual (Page 286)

Chapter 18: SNMPv3
286 Section III: SNMPv3
The SNMP tab is shown in Figure 89 on page 234.
3. In the SNMPv3 section, click the button next to Configure
Community Table, and then click Configure at the bottom of the tab.
The SNMPv3 Community Table tab is shown in Figure 111 on page
283.
4. Click the button next to the SNMPv3 Community Table entry that you
want to change and then click Modify.
The Modify SNMPv3 Community page is shown in Figure 113.
Figure 113. Modify SNMPv3 Community Page
5. In the Community Name field, enter a Community Name of up to 64-
alphanumeric characters.
The value of the Community Name parameter acts as a password for
the SNMPv3 Community Table entry. This parameter is case sensitive.
Note
Allied Telesyn recommends that you select SNMP Community
Names carefully to ensure these names are known only to
authorized personnel.
6. In the Security Name field, enter a name of an SNMPv1 and SNMPv2c
user.
This name must be unique. Enter a value of up to 32 alphanumeric
characters.