Configuring gvrp, Figure 144: gvrp tab (configuration) – Allied Telesis AT-S63 User Manual
Page 362
Advertising
Chapter 22: GARP VLAN Registration Protocol
362
Section V: Virtual LANs
Configuring GVRP
To configure GVRP, perform the following procedure:
1. From the Home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab shown by
default.
3. Select the GVRP tab.
The GVRP tab is shown in Figure 144.
Figure 144. GVRP Tab (Configuration)
4. In the GVRP Parameters section, configure the following parameters
as necessary.
Enable GVRP
Click to enable or disable GVRP.
Advertising