Allied Telesis AT-S63 - Manual (Page 430)

Chapter 27: Secure Shell (SSH)
430 Section VII: Management Security
Configuring SSH
To configure SSH, perform the following procedure:
1. From the Home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Mgmt. Protocols option.
The Mgmt. Protocols page is displayed with the Server-based
Authentication tab selected by default, as shown in Figure 175 on
page 436.
3. Select the Secure Shell tab.
The Secure Shell tab is shown in Figure 173.
Figure 173. Secure Shell Tab (Configuration)
4. Configure the following parameters as necessary:
Status
Enable the SSH server after you have finished the configuration. Or,
click Disabled while you are configuring the protocol. SSH must be
disabled while you are configuring the protocol. This is the default.