Allied Telesis AT-S63 - Manual (Page 137)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Operations 137
3. In the TFTP File Uploads and Downloads section, use the TFTP
Server IP Address field to enter the IP address of the network node
that contains the TFTP server software.
4. For TFTP Operation parameter, click Download.
5. In the TFTP Remote Filename field, enter the filename of the file on
the TFTP server to be downloaded to the switch.
6. In the TFTP Local Filename field, enter a name for the file. This is the
name that the switch uses to store the file in its file system. If you are
downloading the AT-S63 image file into the switch’s application block,
enter “APPBLOCK” as the filename.
7. For the TFTP File Type, select one of the following:
Image
Select this option when downloading a new AT-S63 image file. This
option loads the image file directly into the application block portion of
flash memory so that the switch uses it as its active image file.
Config
Select this option when downloading a configuration file that you want
the switch to use as its active boot configuration file.
File
Select this option to download a file to the file system. For example,
you would select this option if you are downloading a CA certificate or
a boot configuration file you do not want designated as the active boot
configuration file.
8. Click Apply.
The management software notifies you after the download is complete.
Caution
If you downloaded a new AT-S63 image file to the switch’s
application block, the switch decompresses it and writes it to flash
memory. This can require one to two minutes to complete. Do not
reset or power off the unit while it is decompressing the file. After the
file has been decompressed, the switch automatically resets. Your
web browser management session ends. To continue managing the
switch, you must reestablish the management session.