Allied Telesis AT-S63 - Manual (Page 265)

AT-S63 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 265
Enter a name of up to 32 alphanumeric characters.
7. In the Notify Type field, enter one of the following message types:
Trap
Indicates this notify table is used to send traps. With this message
type, the switch does not expects a response from the host.
Inform
Indicates this notify table is used to send inform messages. With this
message type, the switch expects a response from the host.
8. In the Storage Type field, select one of the following storage types for
this table entry:
Volatile
Select this storage type if you do not want the ability to save an entry in
the Notify Table. After making changes to a Notify Table entry with a
Volatile storage type, the Save Config option is not displayed on the
Configuration menu.
NonVolatile
Select this storage type if you want the ability to save an entry in the
Notify Table. After making changes to a Notify Table entry with a
NonVolatile storage type, the Save Config option is not displayed on
the Configuration menu.
The Row Status parameter is a read-only field in the web browser
interface. The Active value indicates the SNMPv3 Notify Table entry
takes effect immediately.
9. Click Apply to update the SNMPv3 Notify Table.
10. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Deleting a Notify
Table Entry
To delete an entry in the SNMPv3 Notify Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 38.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 89 on page 234.
3. In the SNMPv3 section, click the button next to Configure Notify
Table, and then click Configure at the bottom of the tab.