Allied Telesis AT-S63 - Manual (Page 341)

AT-S63 Management Software Web Browser Interface User’s Guide
Section IV: Spanning Tree Protocols 341
Resetting MSTP to the Default Settings
To reset MSTP to the factory default settings, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab selected by
default, as shown in Figure 25 on page 94.
3. Select the Spanning Tree tab.
The Spanning Tree tab is shown in Figure 133 on page 320.
4. Click Configure.
The expanded MSTP Spanning Tree tab is shown in Figure 134 on
page 323.
5. Click Defaults.
The MSTP settings are returned to their default values.
6. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)