Allied Telesis AT-S63 - Manual (Page 195)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Operations 195
Classifier List
The classifiers to be assigned to the policy. The specified classifiers
must already exist. To select more than one classifier, use <Ctrl> click.
5. Click Apply.
6. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Deleting a Flow
Group
To delete a flow group, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by default,
as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Services option.
The Services page is displayed with the CoS tab selected by default,
as shown in Figure 59 on page 182.
3. Select the flow group you want to delete and click Delete.
The flow group is deleted from the list.
Displaying Flow
Groups
To display the flow groups, perform the following procedure:
1. From the Home page, select Monitoring.
The Monitoring System page is displayed with the General tab
selected by default, as shown in Figure 6 on page 42.
Note
You can access the Classifiers tab either through the Network
Security menu option or through the Services menu option. This
procedure uses the path through the Services menu option.
2. From the Monitoring menu, select the Services option.
The Services menu is displayed with the CoS tab selected by default,
as shown in Figure 59 on page 182.
3. Select the Flow Group tab.