Allied Telesis AT-S63 - Manual (Page 163)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Operations 163
5. Configure the following parameters as desired:
ID
Specifies an ID number for the classifier. Every classifier on the switch
must have a unique ID number. The range is 1 to 9999. This parameter
is required.
Description
Specifies a description for the classifier. A description can be up to
fifteen alphanumeric characters. Spaces are allowed.
Destination MAC
Defines a traffic flow by its destination MAC address.
Source MAC
Defines a traffic flow by its source MAC address.
Ethernet Format
Defines a traffic flow by the format of the Ethernet packets. Selections
are:
ˆ Untagged - Ethernet II untagged packets
ˆ Tagged - Ethernet II tagged packets
ˆ 802.2 untagged - Ethernet 802.2 untagged packets
ˆ 802.2 tagged - Ethernet 802.2 tagged packets
Priority
Defines a traffic flow by the user priority level in tagged Ethernet
frames. The range is 0 to 7.
VLAN ID
Defines a traffic flow of tagged packets by its VLAN ID number. The
range is 1 to 4094.
Protocol
Defines a traffic flow as one of the following Layer 2 protocols:
ˆ User Specified
ˆ IP
ˆ ARP
ˆ RARP
User Specified Protocol
Defines a traffic flow of a Layer 2 protocol by its protocol number. The
number can be entered in either decimal or hexadecimal format. For
the latter, precede the number with “0x”. To use this parameter, the
Protocol parameter must be set to User Specified.