Configuring port parameters, Figure 20: port settings tab (configuration) – Allied Telesis AT-S63 User Manual
Page 78
Chapter 5: Port Parameters
78
Section I: Basic Operations
Configuring Port Parameters
To configure the parameter settings of a port on the switch, perform the
following procedure:
1. From the Home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Layer 1 option.
The Layer 1 page is displayed with the Port Settings tab selected by
default, as shown in Figure 20.
Figure 20. Port Settings Tab (Configuration)
3. Click the port in the graphical switch image that you want to configure.
The selected port turns white. You can select more than one port at a
time to configure. (To deselect a port, click it again.)
4. Click Modify. To configure all the ports, click Modify All.
Note
If you select Modify All, you cannot configure the port name or set
the speed and duplex mode. The speed and duplex mode are set to
autonegotiate.