Configuring the snmpv3 view table, Creating a view table entry – Allied Telesis AT-S63 User Manual
Page 244
Chapter 18: SNMPv3
244
Section III: SNMPv3
Configuring the SNMPv3 View Table
You can create, delete, and modify an SNMPv3 View Table entry. See the
following procedures:
“Creating a View Table Entry” on page 244
“Deleting a View Table Entry” on page 247
“Modifying a View Table Entry” on page 247
For reference information about the SNMPv3 View Table, see Chapter 22,
“SNMPv3” in the AT-S63 Management Software Menus Interface User’s
Guide.
Creating a View
Table Entry
To create an entry in the SNMPv3 View Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 38.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 89 on page 234.
3. In the SNMPv3 section, click the button next to Configure View Table
and then click Configure at the bottom of the tab.