Allied Telesis AT-S63 - Manual (Page 415)

AT-S63 Management Software Web Browser Interface User’s Guide
Section VI: Port Security 415
RADIUS Accounting
The AT-S63 management software supports RADIUS accounting for ports
operating in the Authenticator role. The accounting information sent by the
switch to a RADIUS server includes the date and time when clients log on
and log off, as well as the number of packets sent and received by a switch
port during a client session. For background information on this feature,
refer to Chapter 31, “802.1x Port-based Network Access Control” in the
AT-S63 Management Software Menus Interface User’s Guide. This
feature is disabled by default on the switch.
Configuring
RADIUS
Accounting
To configure RADIUS accounting, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by default,
as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Network Security option.
The Network Security page opens with the Port Security tab selected
by default, as shown in Figure 156 on page 394.
3. Select the 802.1x Port Access tab.
The 802.1x Port Access tab is shown in Figure 160 on page 400
4. In the Configure RADIUS Accounting section, configure the following
parameters as necessary.
Enable Accounting
This parameter activates or deactivates RADIUS accounting on the
switch. Select Enabled to activate the feature or Disabled to deactivate
it. The default is Disabled.
Trigger Type
This parameter specifies the action that causes the switch to send
accounting information to the RADIUS server. The possible settings
are:
Start_Stop - The switch sends accounting information whenever a
client logs on or logs off the network. This is the default.
Stop - The switch sends accounting information only when a client logs
off.
Port Number
Specifies the UDP port for RADIUS accounting. The default is port
1813.