Allied Telesis AT-S63 - Manual (Page 402)

Chapter 25: 802.1x Port-based Network Access Control
402 Section VI: Port Security
Enabling or Disabling 802.1x Port-based Network Access Control
To enable or disable 802.1x Port-based Network Access Control, perform
the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Network Security option.
The Network Security page opens with the Port Security tab selected
by default, as shown in Figure 156 on page 394.
3. Select the 802.1x Port Access tab.
The 802.1x Port Access tab is shown in Figure 160 on page 400.
4. Click the Enable Port Access check box. A check in the box means
the feature is activated on the switch. No check means the feature is
disabled.
For instructions on configuring the accounting feature, refer to
“RADIUS Accounting” on page 415.
5. Click Apply.
A change to the status of 802.1x Port-based Network Access Control
is immediately implemented on the switch.
6. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)