Allied Telesis AT-S63 - Manual (Page 184)

Chapter 14: Class of Service
184 Section II: Advanced Operations
Mapping CoS Priorities to Egress Queues
This procedure explains how to change the default mappings of CoS
priorities to egress priority queues. To change the mappings, perform the
following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Services option.
The Services page is displayed with the CoS tab selected by default,
as shown in Figure 59 on page 182.
3. Select the Queuing & Scheduling tab.
The Queuing & Scheduling tab is shown in Figure 61.
Figure 61. Queuing & Scheduling Tab (Configuration)