Allied Telesis AT-S63 - Manual (Page 318)

Chapter 19: Spanning Tree and Rapid Spanning Tree Protocols
318 Section IV: Spanning Tree Protocols
Edge-Port
Whether or not the port is operating as an edge port. The possible
settings are Yes and No.
Point-to-Point
Whether or not the port is functioning as a point-to-point port. The
possible settings are Yes, No, and Auto Detect.
Cost
Port cost of the port. The default is Auto Update.
Priority
The number used as a tie-breaker when two or more ports have equal
costs to the root bridge.
6. Click OK to close the page.
Resetting RSTP
to the Default
Settings
To reset RSTP to the default settings, perform the following procedure:
1. From the Home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38.
2. From the Configuration menu, select Layer 2.
The Layer 2 page is displayed with the MAC Address tab shown by
default, as shown in Figure 25 on page 94.
3. Select the Spanning Tree tab.
The Spanning Tree tab is shown in Figure 123 on page 302.
4. Verify that there is no check in the Enable Spanning Tree check box.
If there is a check, click the option to remove it. Spanning tree must be
disabled in order for you to return it to its default settings.
5. Click Configure.
The Configure RSTP Bridge Parameters tab is shown in Figure 129 on
page 313.
6. Click Defaults.
The RSTP settings are returned to their default values.
7. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)