Allied Telesis AT-S63 - Manual (Page 92)

Chapter 5: Port Parameters
92 Section I: Basic Operations
Resetting a Port to the Default Settings
To reset a port to the default settings, perform the following procedure:
1. From the Home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Layer 1 option.
The Layer 1 page is displayed with the Port Settings tab selected by
default, as shown in Figure 20 on page 78.
3. Click the port in the graphical switch image that you want to configure.
The selected port turns white. You can select more than one port at a
time to configure. (To deselect a port, click it again.)
4. Click Modify. To configure all of the ports, click Modify All.
The Port Configuration page is displayed, as shown Figure 21 on page
79.
5. Click Defaults.
The port(s) are returned to the default settings.