Allied Telesis AT-S63 - Manual (Page 266)

Chapter 18: SNMPv3
266 Section III: SNMPv3
The SNMPv3 Notify Table tab is shown in Figure 102 on page 264.
4. Click the button next to the Notify Table entry that you want to delete,
and then click Remove.
A warning message is displayed.
5. Click OK.
6. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Modifying a
Notify Table
Entry
To modify an entry in the SNMPv3 Notify Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 38.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 89 on page 234.
3. In the SNMPv3 section, click the button next to Configure Notify Table,
and then click Configure at the bottom of the tab.
The SNMPv3 Notify Table tab is shown in Figure 102 on page 264.
4. Click the button next to the table entry that you want to change and
then click Modify.
The Modify SNMPv3 Notify page is shown in Figure 104.
Figure 104. Modify SNMPv3 Notify Page
5. In the Notify Tag field, enter a description name of the Notify Tag.