Displaying the encryption keys, Figure 169: keys tab (monitoring) – Allied Telesis AT-S63 User Manual
Page 422
Chapter 26: Encryption Keys, PKI, and SSL
422
Section VII: Management Security
Displaying the Encryption Keys
To configure the encryption keys, you must use the AT-S63 menus or
command line interface. For more information about encryption keys, refer
to the AT-S63 Management Software Menus Interface User’s Guide.
To display the encryption keys, perform the following procedure:
1. From the Home page, select Monitoring.
The System page is displayed with the General tab selected by
default, as shown in Figure 6 on page 42.
2. From the Monitoring menu, select the Mgmt. Security option.
The Mgmt. Security page is displayed with the Mgmt. ACL tab
displayed by default, as shown in Figure 182 on page 454.
3. Select the Keys tab.
The Keys tab is shown in Figure 169.
Figure 169. Keys Tab (Monitoring)
The Keys tab displays a table that contains the following columns of
information:
ID
The identification number of the key.
Algorithm
The algorithm used in creating the encryption. This is always RSA -
Private.