Allied Telesis AT-S63 - Manual (Page 449)

AT-S63 Management Software Web Browser Interface User’s Guide
Section VII: Management Security 449
The Mgmt. Security page is displayed with the Mgmt. ACL tab selected
by default, as shown in Figure 181.
Figure 181. Mgmt. ACL Tab (Configuration)
The middle section of the tab lists the existing ACEs on the switch. The
bottom portion is used to add and delete entries. For instructions, refer
to “Creating an ACE” on page 451 and “Deleting an ACE” on
page 453,
3. Click either Enable MGMT. ACL or Disable MGMT. ACL. The default
setting is disabled.
4. Click Apply.
A change to the status of the management ACL is immediately
activated on the switch.
Note
If you activate the feature before entering an access control entry
that specifies your management workstation, either by its IP address
or subnet, your web browser management session will end and you
will not be able to reestablish it.