Allied Telesis AT-S63 - Manual (Page 330)

Chapter 20: Multiple Spanning Tree Protocol
330 Section IV: Spanning Tree Protocols
Adding, Removing, or Modifying VLAN Associations to MSTIs
This section explains how to add or remove VLANs associated to MSTI
IDs.
Adding a VLAN
Association
To add a VLAN association, perform the following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab selected by
default, as shown in Figure 25 on page 94.
3. Select the Spanning Tree tab.
The Spanning Tree tab is shown in Figure 123 on page 302.
4. Click Configure.
The expanded MSTP Spanning Tree tab is shown in Figure 134 on
page 323.
5. In the CIST/MSTI Table section of the tab, the VLAN Associations
field, enter the VIDs of the VLANS to be associated with this MSTI.
You can specify more than one VID at a time (for example, 2,4,7).
6. Click Apply.
7. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Or, proceed to the next procedure to configure the CIST priority.
Removing a
VLAN
Association
To remove a VLAN association, perform the following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab selected by
default, as shown in Figure 25 on page 94.