Allied Telesis AT-S63 - Manual (Page 157)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Operations 157
Output Status
Specifies whether or not the output is sent to the syslog server. The
options are:
Enabled - Sends the output to the syslog server.
Disabled - The output is not sent to the syslog server even if an IP
address is defined.
Message Format
Specifies the format of the messages sent to the syslog server. The
options are:
Extended - Displays the time, module, severity, description, file name,
line number, and event ID. This is the default.
Normal - Displays the time, module, severity, and description for each
event.
Severity Selections
Specifies the severity of events you want to send to the syslog server.
The possible options are:
ALL - All messages of the following types are displayed. This is the
default.
Error - Only error messages are displayed. Error messages indicate
that the switch operation is severely impaired.
Warning - Only warning messages are displayed. These messages
indicate that an issue may require manager attention.
Information - Only informational messages are displayed.
Informational messages display useful information that you can ignore
during normal operation.
Debug - Debug messages provide detailed high-volume information
that is intended only for technical support personnel.
Use <Ctrl>+click to select more than one severity at a time.
Type
The only available type is Syslog and you cannot change this.
Syslog Server IP Address
The IP address of the syslog server.
Facility Level
The numerical code to be added to the entries sent to the syslog
server to group the entries according to the module or switch that
produced them.
The facility levels are described in Table 3 on page 154.