Allied Telesis AT-S63 - Manual (Page 67)

AT-S63 Management Software Web Browser Interface User’s Guide
Section I: Basic Operations 67
The Add New SNMPv1 & SNMPv2c Community page is shown in
Figure 16.
Figure 16. Add New SNMPv1 & SNMPv2c Community Page
6. Configure the following parameters:
Community Name
Enter an SNMP community name that consists of up to 15
alphanumeric characters.
Status
Click Enable to enable the SNMP community. Click Disable to disable
the SNMP community.
Access Mode
Click Read Only to allow read access to the SNMP community. To
allow read-write access to the SNMP community, click Read-Write.
Allow Any Station
Click this option to allow any SNMP manager to access the switch.
When you click this option, a warning message appears on the screen.
Click OK to continue.