Allied Telesis AT-S63 - Manual (Page 316)

Chapter 19: Spanning Tree and Rapid Spanning Tree Protocols
316 Section IV: Spanning Tree Protocols
Edge Port
This parameter defines whether the port is functioning as an edge port.
The possible settings are Yes and No. For an explanation of this
parameter, refer to “Point-to-Point and Edge Ports” in Chapter 23,
“Spanning Tree and Rapid Spanning Tree Protocols” in the AT-S63
Management Software Menus Interface User’s Guide.
4. After you have configured the parameters, click Apply.
5. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Displaying RSTP
Settings
To display RSTP parameter settings, perform the following procedure:
1. From the Home page, select Monitoring.
The Monitoring System page is displayed with the General tab
selected by default, as shown in Figure 6 on page 42.
2. From the Monitoring menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab displayed by
default.
3. Select the Spanning Tree tab.
The Spanning Tree tabs is shown in Figure 126 on page 309.
This tab displays information on whether spanning tree is enable or
disabled and which protocol version, STP or RSTP, is active.
4. Click View.