Allied Telesis AT-S63 - Manual (Page 194)

Chapter 15: Quality of Service
194 Section II: Advanced Operations
Modifying a Flow
Group
To modify a flow group, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Services option.
The Services page is displayed with the CoS tab selected by default,
as shown in Figure 59 on page 182.
3. Select the flow group you want to modify and click Modify.
The Modify Flow Group page is displayed, as shown in Figure 67.
Figure 67. Modify Flow Group Page
4. Configure the following parameters as necessary:
ID
Specifies the ID number for this flow group. The range is 0 to 1023.
DSCP
Specifies a replacement value to write into the DSCP (TOS) field of the
packets. The range is 0 to 63.
Remark Priority
Replaces the user priority value in the packets with the new value
specified in the Priority parameter.
Description
Specifies the flow group description. A description can be up to 15
alphanumeric characters, including spaces.
Priority (802.1p)
Specifies a new user priority value for the packets. The range is 0 to 7.